Float control: Place both the draft control lever and the position control lever in the float position to make the lower links move freely along with the ground conditions.Only draft control and my device adds this much needed option to the original Ferguson system lift. 8n Ford Draft Control found in: Draft Control Spring Plate without Pin, Draft Control Spring, Hydraulic Lift Draft Control Plunger, Inner Hydraulic Lift Control Rod Pin (aka Draft Control Arm Cam Pin), …741, 771, 800. plug on these tractors 87 Ford Tractor Dexta Draft Control Link Assembly. Position control is being able to maintain a selected height of the lift arms or 'position control' The 9N/2N Ford and The TO Fergusons that have the Ferguson system lift did not have position or height control. All N-Series Tractors - Ford-Ferguson 9N, 2N, and Ford 8N. Going too deep and causing loss of traction and ground speed. If So, Check Out Our Selection Of Ford - New Holland New & Used Tractor Parts. All tractors are equipped with hydraulic control system for operating three-point hitch of. Point where the implement is at the desired depth. To limit the degree, the implement can be lowered, set the position control lever at the lowest working depth desired for the implement. However, the implement sometimes lowers too much. Mixed control: In draft control, when draft decreases, the implement automatically lowers to increase draft. Fits a Ford 8N, 9N, 2N, Jubilee, NAA, 2000 (4 cylinder), 4000 (4 cylinder), 600, 601, 700, 701, 800, 801,900, 901, Dexta, Super Dextaor Ferguson TO20 or TO30.Place the position control lever in the lowest position and set the implement pull with the draft control lever. Ford ford hydraulic tractor 8n jubilee diagram fluid schematic tractors lift control draft hydraulics gear parts shifter around yesterdaystractors Aug. FORD 9N 8N NAA 600 800 TRACTOR HYD HYDRAULIC SUPPORT DRAFT CONTROL SEAT 2N624. As the load on the 3-point hitch changes due to various soil conditions, the draft control system automatically responds to these changes by either raising or lowering the implement slightly to maintain a constant pull. draft Control Spring 8N- 541-B 8N 1948-53. Position control is being able to maintain a selected height of the lift arms or 'position control' The 9N/2N Ford and The TO Fergusons that have the Ferguson system lift did not have position or height control.
Draft control: This will control the pull of the 3-point implement. This is 'Draft control' Zane Added on Date: 16:43:10 09/01/04.
0 kommentar(er)
